You can now include pour and pour unit template fields and UDAs in the IFC4 export. When you receive a generic error message in Trimble Connector, you can now find further information about the error in an error log file that is generated in the model folder. You cannot accidentally snap anymore to the reference model extrema bounding box. Wraparound gusset cross (60): Previously, connection plates were not correctly extended to create a slot through the main or secondary parts. Base plate (1047): Previously, when one row or column of bolts was defined, the edge distance of the bolts was incorrect. This has now been fixed.īent plate (151): Previously, stiffeners were not created with the correct length. This has now been fixed.Ĭreate hole around part (92): Previously, the hole was incorrectly rotated in some cases. Shear plate simple (146): When the secondary part was already cut before applying the component, incorrect part geometry was used when positioning bolts. Working with the Ship ladder (1) component is now must faster than before. Gusseted cross (62): The default bolt spacing for angle bolts is now the same both when you enter the number of bolts and when you do not enter the number of bolts. Kingspan File transfer (18) was incorrectly removing valid holes in the MultiBeam sections. Wall to wall connection can now be used on beams based on b×h.Ĭolumn with stiffeners W (182), Column with stiffeners S (187) and JP floor beam gusset (11): Previously, the component disappeared when the same component was created near to it. Two sided seating with dowel (76): The drainage hole is now created properly. Rectangular column reinforcement (83): Bottom/Top crank geometry offset is now applied properly. This has now been fixed and miscellaneous parts are also considered. Mesh bars: The bars now always have at least the minimum length set in the Mesh bars dialog box.Įmbedded anchors (8): Previously, only concrete parts have been taken into calculations when using the Assembly without steel parts option on the Placement tab. Layout tools: The UDA files and UDA files are now correctly read from the firm, project, and model folders.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |